|
Specifications:
Continuous current: 12A
Peak current: 16A
Controller use: Airplane/Helicopter
BEC output: 5V / 1A 2~3 servos
BEC type: Linear
Ni-MH cells supported (Voltage): 5~12cells
Li-Po cells supported (Voltage): 2~4cells
Weight: 10g
Dimensions of PCB plus capacitors: Length: 22mm, Width: 22mm, Depth: 6mm
Input wire length from (Red/Black): 58mm
Output wire length (3x Black): 49mm
Supplied with universal ‘JR’ style lead and plug.
General features:
Ø Extremely high rpm ability that can support virtually all the current brushless motors in the market
Ø Super smooth and accurate linear acceleration
Ø Safe start function
Ø Protection from losing remote control signal
Ø Over temperature protection automatically reduces power output at 110℃, until controller temperature recovers to below 110℃
Ø Robust BEC circuits ability of driving servo, surpass all ESC in current market
Ø Suitable for all types of brushless motors
Ø Extensive programming functions
Programmable functions:
Ø Brake setting
Ø Battery type （Li-Po or Ni-MH/NiCad）
Ø Cut-off voltage setting
Ø Restore factory setting
Ø Motor timing
Ø Acceleration on start up (hard, soft, very soft)
Ø Helicopter mode (for Helicopter models)
Ø Motor direction (clockwise/counter clockwise)
Ø Operation frequency
Ø Low voltage cut-off type (slow down or shutdown immediately)
All ZTW speed controllers are supplied without an on/off switch. I feel this is a positive move and firstly eliminates the risk of accidently leaving the drive battery connected leading to irreversible damage to your Li-Po battery and secondly removes the need to fasten the switch securely to prevent accidental switch off.
All ZTW speed controllers feature the same programming. Programming can be accessed using either your transmitters stick or with the optional programme card that we would strongly recommend.
ZTW controllers are supplied without connectors but feature pre-tinned wires for easy soldering.
ZTW controllers are supplied bagged
|
Apparel / Clothing
Bags and Carry Cases
