|
Although the ZTW range of speed controllers are fully programmable using only your transmitter stick, nothing beats the simplicity and ease of using a programming card. The ZTW program card eliminates the need to run through the cursory bleeps that form the programming sequence on many programmable controllers and is easily set using jumpers on the sides of the card. Using the card couldn’t be simpler. Once you have altered the jumpers to your required settings just plug your ESC servo lead to the top left of the card indicated by - + P, plug up your ESC to the drive battery and a beep later you’re complete. Disconnect the drive battery, insert the ESC servo lead to the throttle channel of your RX and fly.
Dimensions: Length: 49mm, Width: 30mm, Weight: 6.5g
Remember, one card operates all the speed controllers in the range making your life simple and your costs low.
Programmable functions:
Ø Brake setting
Ø Battery type (Li-Po or Ni-MH/NiCad）
Ø Cut-off voltage setting
Ø Restore factory setting
Ø Motor timing
Ø Acceleration on start up (hard, soft, very soft)
Ø Helicopter governor mode (for Helicopter models)
Ø Motor direction (clockwise/counter clockwise)
Ø Operation frequency
Ø Low voltage cut-off type (slow down or shutdown immediately)
|
Apparel / Clothing
Bags and Carry Cases
