ZTW 3A 5-6v Switch Mode UBEC
[ZTW UBEC]

Specification Of 3A UBEC:

1. Switch Mode
2. Output: 5V/3A or 6V/3A switchable (Changeable with a blue jumper)
3. Input: 6V-25V (2-6S Lipo, 5-18S NiMH/NiCd)
4. Output Current: Continuous Current 3A, Burst Current 8A
5. Size: 30.0mm*9.0mm*6.0mm(Length*Width*Height)
6. Weight:7.0g

Features:

1. Adopting the USA CPU and decreasing the electromagnetic interference, to be sure that receiver works well .
2. The working status of UBEC is shown by an indicator (LED). When UBEC works, the blue LED lights.
3. Battery polarity reversal protection (If the connection is wrong, the UBEC can not work.)

How to Use the UBEC, please carefully look at the connections as follows : (See Photo)

1. Connecting UBEC with ESC OPTO, you just parallelly connect the input connector of UBEC with the battery pack, and plug the output connector of the UBEC into one of spare channels of the receiver.
2. Using ESC SBEC, you must remove the red wire of the signal wires of ESC SBEC to receiver before connecting with the UBEC. (the connection with ESC SBEC is same as connection with the ESC OPTO)

Note: 

Because of the weather and ground, please connect the UBEC at least in a distance 5cm far away from the receiver to avoid the electromagnetic interference.