High power, high current, high-performance power conversion circuit. The iCharger series uses advanced synchronous buck-boost DC/DC converter technology with an output conversion efficiency that can reach over 90%. This not only saves power and reduces heat buildup, but also makes the charger more compact and conveniently mobile.
Input voltage ranges from 4.5V to 38V. The output power can be adjusted to align with the available input power, thus preventing input current overload and protecting the DC source.
The iCharger series has a built in integrated cell balancer and can be used with three types of Lithium batteries (LiPo, Lilo, LiFe).
Internal temperature sensor and temperature controlled automatic cooling FAN controls the internal temperature and provides intelligent protection. When the internal temperature is over 60℃(140 F), the output power is automatically reduced by 25%. If the temperature exceeds 65℃(149 F) the charge cycle is stopped.
Convenient set of 10 battery profile memories that can be saved and loaded by number. Storing charge settings such as charge current, cell count, discharge current and capacity.
Backlit LCD screen consisting of 2x16 characters providing rich information including active mode, current, voltage, total charge (mAh), charging time and temperature and per cell voltage (for Lithium batteries in balance mode).
Various charging/discharging settings and cycles to meet a wide range of customer needs. For Lithium batteries; balance charging, normal charging, fast charging, storage, discharging, ext-discharging, charge/discharge cycling, and battery monitoring. For NiCd/NiMH batteries; charging-auto, charging-manual, discharging, charge/discharge cycling and forming charge. For Pb batteries; charging and discharging.
Storage charge function that charges the battery to user set capacity. For long term storage and care of the battery.
Greater control over balance charge setting. Either set to start balance charging when voltage reaches a user set value, or start balancing from beginning or part way through the (Lithium) charge cycle.
Unique Lithium battery expanding discharge program. When you connect an external capacity resistor, iCharger produces maximum discharge power capacity of 1200W (@40V/30A).
Unique Lithium battery monitoring program. When you use other equipment to charge or discharge a Lithium pack, you can use the iCharger to monitor the per-cell voltages, battery temperature and process time. If any individual cell appears over-charged or over-discharged or the pack is too hot or the process has gone on for too long, the iCharger will generate an alarm sound and the related information will blink.
Automatically checks number of cells in a pack to see if this matches user set setting before beginning any function.
Electric motor test mode can be used to run-in electric motors, test motor parameters and performance as well as check tolerances.
Foam-cut drive. In this mode, the charger acts as a convenient power supply for a hot wire foam cutter.
Battery internal resistance measurement. The iCharger can not only measure the internal resistance of the battery pack, and also can measure the per-cell internal resistance (only available for Lithium battery).
Perfect protection. The iCharger has protection for reversed polarity (input or output), low input voltage, battery temperature, charging capacity and time overrun.
iCharger 306B has a 16Mbit flash storage, which can log offline charge and discharge data for the past 31 hours.
iCharger is firmware upgradable via its USB connection to a PC.
iCharger supports “logview” software. Allowing display and analysing the charge and discharge data.
Apparel / Clothing
Bags and Carry Cases
